Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
dev:slog_endgame [2009/09/26 13:12] philippe |
dev:slog_endgame [2018/02/07 16:07] 127.0.0.1 external edit |
</code> | </code> |
| |
Then, to perform the following you may need: | |
| |
<code> | |
$ sudo apt-get install subversion | |
$ sudo apt-get install autoconf | |
$ sudo apt-get install build-essential | |
</code> | |
| |
Then, | Then, |
</code> | </code> |
| |
You may well have to install more development packages, but the configure script will probably tell you about those. | You may well have to install more development packages, but the configure script will probably tell you about those. Check [[dev:contributing|this link]] for more suggestions. On a clean Ubuntu installation the following was needed: |
| |
| <code> |
| $ sudo apt-get install subversion build-essential automake ladspa-sdk liblircclient-dev libjack-dev dssi-dev liblrdf-dev libfftw3-dev xutils-dev |
| </code> |
| |
| |
For the old KDE3 codebase we used a comprehensive CMake-based build system; this has never (yet) been converted to the new code, so we are testing a simpler autoconf configuration instead. It should work, but it's not guaranteed. If you find fixable problems, please report them to the -devel list. | For the old KDE3 codebase we used a comprehensive CMake-based build system; this has never (yet) been converted to the new code, so we are testing a simpler autoconf configuration instead. It should work, but it's not guaranteed. If you find fixable problems, please report them to the -devel list. |