Differences

This shows you the differences between two versions of the page.

--- doc:pitchbendsequencedialog-en [2010/01/12 08:45]
janifr created
+++ doc:pitchbendsequencedialog-en [2012/01/23 03:56]
chrisstout [Usage] Updated instruction for added a pitch bend, correct for 11.06 and 11.11.42
@@ Line 8: / Line 8: @@
 Open matrix editor and select the events you want to apply the bends. Please note that the events you select are not modified, the selection is only used for start and end times of bends.
-Select Adjust->Pitch Bend Sequence... from menu. The dialog should open.
+Select Edit -> Insert Pitch Ben Sequence... from menu.  The dialog should open.
 ==== Parameters ====
@@ Line 28: / Line 29: @@
 Duration of the pre bend compared to whole selected range. If set to 100% no bend sequence is applied.
 === Bend Sequence ===
+In this box you specify the parameters for the series of bend events.
 == Ramp duration (%) ==
+Duration of the linear ramp in per cents compared to time of selected events minus time of pre bend. Ramp ends before the sequence if lower than 100%.
 == End value (%) ==
+The pitch at end of the ramp in per cents.
 == Vibrato start amplitude (%) ==
+This defines amplitude of the vibrato at beginning of the bend sequence.
 == Vibrato end amplitude (%) ==
-== Vibrato wavelength (%) ==
+This defines amplitude of the vibrato at end of the bend sequence.
+== Vibrato wavelength ==
+This defines frequency of vibrato. Defined as resolution units. See below.
 == Resolution ==
+Sequence is divided in this many pieces.